ThinkAgile CP - Enable memory oversubscription on the compute controller

This section covers the procedure to enable the memory oversubscription service on the compute controller.

Note:

By default, the memory oversubscription service daemon is not enabled.
If you are using a hardware stack with multiple compute controllers, you need to enable the memory oversubscription service on each compute node.

To enable memory oversubscription, follow these steps:

Execute the following command to start the memory oversubscription service:
sudo systemctl start tacp-memory-oversubscription.service
Execute the following command to ensure the service is up and running:
sudo systemctl status tacp-memory-oversubscription.service

Figure 1. Verifying the memory oversubscription service is running
Execute the following command to set the service to start on reboot:
sudo systemctl enable tacp-memory-oversubscription.service