Create routes for the VNET

For the interconnect switch to route the newly created subnet for the VNET, the route must be created on the interconnect switch.

Complete the following steps to create a route on the interconnect switch:

  1. Establish an SSH session with the the interconnect switch.
  2. Run the following command:

    sudo /usr/share/tacp/export_bgp_route.sh add 100.127.4.0 24 100.65.0.29

    Command: export_bgp_route.sh {add|del} {VNET Network} {VNET CIDR} {Outside NFV IP}
    manager@Interconnect-Primary:~$ sudo /usr/share/tacp/export_bgp_route.sh add 100.127.4.0 24 100.65.0.29 
    Synchronizing configuration...OK. 
    Pica8 PicOS Version 2.11.5.tacp.1 
    Welcome to PicOS on Interconnect-Primary 
    root@Interconnect-Primary>Execute command: configure. 
    Entering configuration mode. 
    There are no other users in configuration mode. 
    Execute command: set protocols static route 100.127.4.0/24 next-hop 100.65.0.29. 
    Execute command: commit 
    . 
    Commit OK. 
    Save done. 
    Synchronizing configuration...OK. 
    Pica8 PicOS Version 2.11.5.tacp.1 
    Execute command: configure. 
    Entering configuration mode. 
    There are no other users in configuration mode. 
    Execute command: set protocols bgp network4 100.127.4.0/24. 
    Execute command: commit 
    . 
    Commit OK. 
    Save done.
    Note:

    For a dual interconnect configuration, the command needs to be run on both interconnect switches.

  3. Exit.